Another video skate DIY. Read to learn more about materials, etc.: The wood is commonly known as sugar maple (Hard Maple Skate Rock is a concept known, began in the 70s or early 80s). Rotary cut veneer with a thickness of 1 / 16 inch. I bought a mill in Quebec, Canada was called The Great and wood veneer, the nature of the sale at that time a man named Dale rosemary, but I have no idea if he is still there. Currently I think that wood is more than a dollar per square meterFoot (unless your willing to buy by the truckload.) There are about 18 square meters on each board. I can with glue - PVA (white carpenters glue) with a catalyst (aluminum chloride), which is corrosive and mix only by commercial suppliers. This catalyst causes the adhesive cross-borrowing "Building a top link. Adhesive with a hard rubber roller, this is the easiest way to ensure consistent application of the tail with his hand. Do not put the two sides of the fillets or moreQueue! This additional adhesive will be something like an extra layer of soft, a meeting of the Sun causes any remaining catalyst must be properly disposed of as hazardous material. This particular catalyst increases the time to dry a bit, 'but may be offset by the warming of the form in which it behaves like a normal white glue again. Normal PVA works well, just go fast when you make your paste! Moho - The Bondo car after my opinion, because it was the cheapest material that could be...
http://www.youtube.com/watch?v=iCqt1Q-nJ9Q&hl=en
No comments:
Post a Comment